Tech Tip

Posted by Jeff Coulter on

Tech Tip

Tech Tip - a continuing series.

Resetting the calibration data on your ZMorph.
Sometimes your ZMorph VX or FAB will misbehave, and start air printing a couple of mm above the glass, even after a successful Autocalibration.
This is the procedure to reset the stored data:
Instructions Here.

The trick is to make sure to press the RESET button on the right after doing this.
If you power it off instead you will need to do this again.

Contact us if you need some help with this.

Share this post

← Older Post Newer Post →