News — 3D print warping

Print Insurance?

Posted by Jeff Coulter on

Print Insurance?

Print Insurance? It's kind of like print insurance. Tired of the mess with hairspray? Better than glue stick, because this is what it was MADE to do. Dimafix Use Zones - Print Bed Temperature • 0 - 60ºC - weak adherence, objects are easily detached from the plate • 60 - 75ºC - average adherence, recommended for simple geometries • 75 - 95ºC - high adherence, recommended for complex geometries and long lasting prints • Over 95ºC - very high adherence, for very complex geometries and very lengthy prints Get your DIMAFIX Pen here.

Read more →

How to Avoid Warping in Your 3D Prints

Posted by John Marello on

How to Avoid Warping in Your 3D Prints

The Complete Guide: How to Avoid Warping in Your 3D Prints Warping is one of the most common issues any 3D printing enthusiast has faced. It rarely happens that warping causes some serious and dangerous failures. However, it may render your models completely unusable, even though you try your best to get rid of it in post-processing. Here’s why warping occurs and what to do when it happened to you. to read the complete article, click HERE

Read more →