News — ZMorph VX

Demo Model Clearance Sale!!

Posted by John Marello on

Demo Model Clearance Sale!!

In-House Demo 3D Printers & Laser Cutters for Sale!! Profound3D has Creality, ZMorph, Zortrax, Raise3D and Flux Demo Units for Sale at Super Low Prices! All have been maintained by Profound3D's technicians and are in good working order. The chance to purchase a #3DPrinter or #lasercutter with these discounts doesn't come every day, so take advantage of this opportunity to save! View the selection at https://bit.ly/36fsLEB

Read more →

Open Box Mark Down!

Posted by Jeff Coulter on

Open Box Mark Down!

Open Box Mark Down! Fresh markdown pricing on these VERY slightly used ZMorph VX Full Set systems. They have all the accessories, spools of PLA, and work as new. They have been tested and include 90 Warranty Save REALLY BIG bucks on these awesome systems! They have been checked and tested by me, and are ready to ship TODAY! [If you get your order in before 3 PM] Get this special open box offer here.

Read more →

BUY IT BEFORE WE COME TO OUR SENSES!

Posted by Jeff Coulter on

BUY IT BEFORE WE COME TO OUR SENSES!

BUY IT BEFORE WE COME TO OUR SENSES! Open Box Mark Down! Fresh markdown pricing on these VERY slightly used ZMorph VX Full Set. They have all the accessories, spools of PLA, and work as new. They have been tested and include 90 Warranty Save a BIG bucks on these awesome systems! They have been checked and tested by me, and are ready to ship TODAY! [If you get your order in before 3 PM] Get this special open box offer here.

Read more →

ZMorph 3mm Toolhead with FREE filament!

Posted by Jeff Coulter on

ZMorph 3mm Toolhead with FREE filament!

ZMorph 3mm Toolhead with FREE filament! We have one ZMorph 3mm Toolhead in stock and while we have this one it includes 2 free spools of 3mm PLA - get it now while it lasts! Get your ZMorph 3mm Toolhead here.

Read more →

Tech Tip

Posted by Jeff Coulter on

Tech Tip

Tech Tip Tech Tip - a continuing series. Resetting the calibration data on your ZMorph. Sometimes your ZMorph VX or FAB will misbehave, and start air printing a couple of mm above the glass, even after a successful Autocalibration. This is the procedure to reset the stored data: Instructions Here. The trick is to make sure to press the RESET button on the right after doing this. If you power it off instead you will need to do this again. Contact us if you need some help with this.

Read more →