News — Z-FLEX

Zortrax Z-FLEX

Posted by Jeff Coulter on

Zortrax Z-FLEX

Zortrax Z-FLEX Optimized for use on the M200 Plus and M300 Plus, Z-FLEX allows you to make flexible objects that don't snap or break when bent or folded. You can also make gaskets [not really for critical use] and pads and stuff like that. [*Please note that Z-FLEX is intended for use with the Zortrax M200 Plus and M300 Plus 3D printers, and is not intended to work with the original M200 model. Get your Z-FLEX here.

Read more →

Z-FLEX Printing Tip

Posted by Jeff Coulter on

Z-FLEX Printing Tip

Zortrax Z-FLEX Printing Tip Optimized for use on the M200 Plus and M300 Plus, Z-FLEX allows you to make flexible objects that don't snap or break when bent or folded. You can also make gaskets [not for critical use] and pads. Our advice when using this material is to make sure you clean out the Nozzle and Hotend thoroughly after switching ot another material. You will find residue from Z-FLEX likes to hang around, so reload the next. material at least 4 or 5 times before initiating a print job. [*Please note that Z-FLEX is intended for use with the...

Read more →

NEW Z-FLEX IS HERE!

Posted by Jeff Coulter on

NEW Z-FLEX IS HERE!

NEW Z-FLEX IS HERE! If you have been looking to try something flexible on your M200 PLUS or M300 PLUS, look no further! Now shipping for the M200 PLUS and M300 PLUS: Z-FLEX. [*Not recommended for the M200 or M300 Classic systems] Get it here.

Read more →