News — Ideamaker tutorial

Geek Time

Posted by Jeff Coulter on

Geek Time

Geek Time! I setup my old desktop PC here with Debian Linux. It's the flavor of Linux I know pretty well, and I wanted to see how ideaMaker worked on it. It only takes about 45 minutes to setup a running Debian system. Get it here. If you download the NETINST you can then boot from a thumb drive and complete it from there. [this assumes you have an internet connection on the target system] So everything was up and running, and I installed ideaMaker from the supplied .deb file from Raise3D: Get it here. You will probably want the...

Read more →

Beginners Guide to Raise 3D Ideamaker

Posted by John Marello on

Beginners Guide to Raise 3D Ideamaker

IdeaMaker – A Beginner’s Guide to Raise3D’s Slicer IdeaMaker is one of many slicing platforms, but what distinguishes it is its sleek compatibility with dual extruder printers and highly customizable print settings. Check out this tutorial HERE to go through the basics of slicing with Raise3D's IdeaMaker.

Read more →