Test prints w/Purement
Posted by Jeff Coulter on
A couple test prints on the CraftBot PLUS with the Purement anti-microbial filament. A little stringy at 215c [upper end of recommended print temp] but looks very nice indeed at 200c.
The is the 'veroni bear' that comes on your CraftBot USB drive included with the printer. It's a great model and shows lots of characteristics of both the printer and the materials.
Purement information: http://www.bnktech.kr/page/purement
The is the 'veroni bear' that comes on your CraftBot USB drive included with the printer. It's a great model and shows lots of characteristics of both the printer and the materials.
Purement information: http://www.bnktech.kr/page/purement
Share this post
- Tags: 3d printing, CraftBot, PLA, Purement