News — ZMORPH

Tech Tip Tech Tip - a continuing series. Resetting the calibration data on your ZMorph. Sometimes your ZMorph VX or FAB will misbehave, and start air printing a couple of mm above the glass, even after a successful Autocalibration. This is the procedure to reset the stored data: Instructions Here. The trick is to make sure to press the RESET button on the right after doing this. If you power it off instead you will need to do this again. Contact us if you need some help with this.

They Are Here! We warned you they were coming soon... and now, the very first ZMorph i500s on US shores have arrived! This is the first test print off the DEMO unit all cleaned up and after its bath to dissolve the BVOH support material. We are very excited to have the E X C L U S I V E on these first systems. Be the first on your block, heck, be the first in your state to get one! One of them was pre-sold in April - the other five are on a first come first served basis...

They Are Here! We warned you they were coming soon... and now, the very first ZMorph i500s on US shores have arrived! This is the first test print off the DEMO unit: ZMorph's signature Silver PLA and BVOH water-soluble support material. Time to give it a bath in some hot water. We are very excited to have the E X C L U S I V E on these first systems. Be the first on your block, heck, be the first in your state to get one! One of them was pre-sold in April - the other five are on...

They Are Here! We warned you they were coming soon... and now, the very first ZMorph i500s on US shores have arrived! This is the test print run on our DEMO unit: PLA and BVOH water-soluble support material. We are very excited to have the E X C L U S I V E on these first systems. Be the first on your block, heck, be the first in your state to get one! One of them was pre-sold in April - the other five are on a first come first served basis so ACT NOW or you will be...

They Are Here! We warned you they were coming soon... and now, the very first ZMorph i500s on US shores have arrived! This is our DEMO unit running its very first print: PLA and BVOH. Stay tuned for pictures of the final print We are very excited to have the E X C L U S I V E on these first systems. Be the first on your block, heck, be the first in your state to get one! One of them was sold in April - the other five are on a first come first served basis so ACT...