News — 3d printing
Why it was paused... again...
Posted by Jeff Coulter on
It was paused for another filament swap! So easy to do on the Raise3D systems. [pause_layer_number * resolution = pause_at_mm]
- Tags: 3D Architecture, 3d printing, N2 Plus, PLA, raise3d
Paused again... why?
Posted by Jeff Coulter on
The Eiffel Tower build has paused again... but why?
- Tags: 3D Architecture, 3d printing, N2 Plus, PLA, raise3d
Resumed...
Posted by Jeff Coulter on
The Eiffel Tower has resumed... but we're not done yet...
- Tags: 3D Architecture, 3d printing, N2 Plus, PLA, raise3d
Paused... Why?
Posted by Jeff Coulter on
The new Eiffel Tower build is paused [easy to program on the Raise], but why?Tune in later to find out!
- Tags: 3D Architecture, 3d printing, N2 Plus, PLA, raise3d
Another Eiffel Tower build started!
Posted by Jeff Coulter on
This one will be a little different... still on the RAISE3D... still using our PLA... tune in later to see it progress...
- Tags: 3D Architecture, 3d printing, N2 Plus, PLA, raise3d